'68FB Rollbar Install Help - Mustangsandmore Forums

Brought to you in part by:

.

Mustangsandmore Forums

'64 1/2 to '73 -- The Classic Mustang

'68FB Rollbar Install Help

profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone!

next newest topic | next oldest topic

Author	Topic: '68FB Rollbar Install Help
rdw40 Journeyman Posts: 44 From: Hockessin, DE USA Registered: Dec 2002	posted 01-31-2003 09:09 PM Thinking of putting the 4 point Branda rollbar in. Has anyone done this where you have to cut holes in the plastic side panels under the vents and just how do you go about measuring exactly where to cut holes? Use a holesaw? What about welding on tabs to handle a 3 or 5 point seat belt/harness? IP: Logged
Gary Gearhead Posts: 725 From: Sarasota, Fla. USA Registered: Jun 99	posted 02-02-2003 07:42 AM I would contact Branda, they offer the roll bar and I would think someone there should be able to help answer your question/s IP: Logged
RADRIDE Gearhead Posts: 252 From: Va.Beach, Va. Registered: Aug 2002	posted 02-02-2003 09:50 AM I did it on my 65 and its not that hard.Take seats out.Start with rough measurements and cut tight the panel will be cut into the curve.I used a jigsaw.If you notice on a Shelby they cut a pretty big hole.Mine is tight ond looks great.I also used windlace to cover cut and give it a finished look.The only thing is on a 65 the light in the panel had a tube on the backside I cut to make it easier to slide in and out.I had a harder time with my shelf.I wraped my 5pt belts but welding taps should be no problem. IP: Logged

All times are ET (US)	next newest topic \| next oldest topic
Administrative Options: Close Topic \| Archive/Move \| Delete Topic
	Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2003, Steve LaRiviere. All Rights Reserved.

Ultimate Bulletin Board 5.47d

Amazon Honor System

[Acronyms][Calendar][Chat][Classifieds] [Members' Pics]
[ Mustangsandmore.com Bookstore] [Mustangsandmore.com T-Shirts][Tech Articles]