Author
|
Topic: Dipstick question about Canton 7qt oil pans
|
oldmustangjunkie Journeyman Posts: 27 From: Registered: Apr 2002
|
posted 08-21-2002 04:24 PM
I have a 7qt pan by Canton and a blue knurled grip FMS dipstick from Mustangs Plus. Will it read correctly? MP said it would but I have my doubts. I measured and the new dipstick/tube is the same length as my old one.
IP: Logged |
RADRIDE Gearhead Posts: 243 From: Va.Beach, Va. Registered: Aug 2002
|
posted 08-21-2002 04:47 PM
I have the 9 qt Canton and Mustang Plus told me to fill it run it let it sit and mark stick to make sure.I also have same dipstick.
IP: Logged |
V8 Thumper Gearhead Posts: 3529 From: Orange, Ca. United States of America Registered: Dec 2001
|
posted 08-22-2002 12:04 AM
I've got the Canton seven quart (6 in pan, one in filter), p/n# ....610. Alex runs them on his race motors and frequently runs less than a full load 5 1/2 quarts in my pan and one in the filter reads just up to the 'ADD' marker on my stock 289 dipstick... 5+1 barely touched the bottom of the stick, Alex says 4+1 dosen't touch the stick at all 
IP: Logged |
JAAZZY Gearhead Posts: 745 From: Bay Area, CA Registered: Apr 2001
|
posted 08-22-2002 12:31 PM
I have a similar pan from Coast. Actually it looks like the Canton pan so I wonder if it is just relabeled. Anyway, with the pan full it barely touched the stick. I ended up using a Dremel and cutting about an inch off of the tube. I probably should have cut off a bit more but it is now full at the add mark. You could probably do it so that it reads perfectly.
IP: Logged |
Hemikiller Gearhead Posts: 395 From: Clinton, CT Registered: Feb 2002
|
posted 08-22-2002 10:23 PM
JAAAZY has the best solution to your problems. That's how I used to recommend people use their stock dip sticks with those pans.
IP: Logged |