|
Author
|
Topic: I just rebuilt my holley........
|
'69PonyRider
Journeyman Posts: 46
From: Hawthorne, CA
Registered: Sep 2001
|
posted 08-11-2002 11:06 PM
   
Hey guys, I just rebuilt my Holley 650 double pump using one of their rebuild kits and I fired it up today, well I tried....I turned on the car and it ran for about 3 seconds when it turned off. My dad told me that gas was sprouting up from the primary airhorn  What can be causing this? I have no clue what to do. I replaced the gaskets, power valve, pump diaph.,and valve & seats'. Where did I go wrong?  Please help. Aldo.
IP: Logged |
steve'66
Gearhead Posts: 4354
From: Sonoma,CA,USA
Registered: Mar 2000
|
posted 08-11-2002 11:16 PM
Aldo,Your primary float is sticking or adjusted too high. Turn it down and adjust it until the fuel just trickles out the primary bowl's plug. SteveW
IP: Logged |
'69PonyRider
Journeyman Posts: 46
From: Hawthorne, CA
Registered: Sep 2001
|
posted 08-11-2002 11:25 PM
Where do i adjsut it? When i put in the pump diaph's there was this orange plug thing that stuck up and didnt let the float set all the way down, could this be a problem?
IP: Logged |
69 Sportsroof
Gearhead Posts: 130
From: Valley, Alabama, USA
Registered: Mar 2002
|
posted 08-12-2002 07:26 AM
quote:
Originally posted by '69PonyRider:
Where do i adjsut it? When i put in the pump diaph's there was this orange plug thing that stuck up and didnt let the float set all the way down, could this be a problem?
You can clip the orange stem off but not too far down. Clip just enough to make sure the float moves freely and will seat properly.
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
