|
Author
|
Topic: Transmission crossmember
|
bluestreek
Gearhead Posts: 1011
From: Athens,GA
Registered: Jul 2001
|
posted 03-30-2002 10:12 AM
   
Is the crossmember or supports different for a c-4 auto and a manual tranny in a '66. Looking down the road at converting 3spd to auto. Thanks, BS
IP: Logged |
kcode
Gearhead Posts: 2435
From: alvaton,ky,usa Suburb of Bowling Green, M&M #79, MCA #29208
Registered: Jun 99
|
posted 03-30-2002 11:03 AM
They are the same for manual or automatic. 65-66 are the same.Mike
IP: Logged |
sigtauenus
Gearhead Posts: 1708
From: Beaufort, SC
Registered: Jun 2000
|
posted 03-30-2002 01:27 PM
The rubber mount between the crossmember and tranny is the same too. When you have it apart note that there are 4 bolt holes in the rubber mount, all you do is use the other holes (ie, not the 2 used now) when switching 3 spd to automatic.[This message has been edited by sigtauenus (edited 03-30-2002).]
IP: Logged |
bluestreek
Gearhead Posts: 1011
From: Athens,GA
Registered: Jul 2001
|
posted 03-30-2002 06:17 PM
That's good news! 
thanks, BS
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
