Intake install question - Mustangsandmore Forums

Brought to you in part by:

.

Mustangsandmore Forums

'64 1/2 to '73 -- The Classic Mustang

Intake install question

profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone!

next newest topic | next oldest topic

Author	Topic: Intake install question
Calcat Journeyman Posts: 75 From: Los Angeles, CA Registered: Feb 2002	posted 03-09-2002 02:05 AM doing a 4v conversion on 302 with performer intake. Saw that manual called for sealing washers. Found them at Home Depot. Question is do I need them with aluminium aftermarket manifold? IP: Logged
V8 Thumper Gearhead Posts: 3267 From: Orange, Ca. United States of America Registered: Dec 2001	posted 03-09-2002 05:29 AM ??? What manual are you reading? A 1/4" bead of silicon at the ends (in place of the cork end gaskets) is about it, save for the intake flange gaskets themselves. IP: Logged
kcode Gearhead Posts: 2559 From: alvaton,ky,usa Suburb of Bowling Green, M&M #79, MCA #29208 Registered: Jun 99	posted 03-09-2002 11:01 PM I don't know anything about Sealing Washers, but on an Aluminum Intake I would invest in some 5/16 stainless steel washers for under bold heads. I would also get stainless bolts, they look good when polished. The washers will keep the bolt heads from digging into the aluminum. Mike IP: Logged

All times are ET (US)	next newest topic \| next oldest topic
Administrative Options: Close Topic \| Archive/Move \| Delete Topic
	Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2003, Steve LaRiviere. All Rights Reserved.

Ultimate Bulletin Board 5.47d

Amazon Honor System

[Acronyms][Calendar][Chat][Classifieds] [Links] [Members' Pics] [Tech] [ Mustangsandmore.com Bookstore] [Advertise on Mustangsandmore.com] [Mustangsandmore.com T-Shirts]