|
Author
|
Topic: Gas tank and fuel lines
|
Doyle
Journeyman Posts: 38
From: Annapolis, Maryland
Registered: Oct 2000
|
posted 02-23-2002 08:13 AM
   
I recently purchased a new tank, sending unit, and 2piece fuel lines. I installed the sending unit and was wondering if there are any "gotcha's" that anybody can warn me about before I install the tank. The installation just seemed too
easy... I was also thinking about installing the
"tank armour" which I saw in some previous
dicussions. Any opinions on that? Thanks
IP: Logged |
Moneymaker
Administrator Posts: 19751
From: Lyons, IL, USA
Registered: May 99
|
posted 02-23-2002 03:48 PM
Nope, it's as easy as it looks.  ------------------
Alex Denysenko
Co-Administrator and Moderator/ non 65-66 Mustang owner sensitivity co-ordinator NHRA/IHRA/SRA member
NHRA and IHRA SS/LA National Record Holder '00, '01, & '02
Fleet of FoMoCo products including 88 ASC McLaren Mustang #28
Part time secret agent license #0089
US Class Nationals link
IP: Logged |
Fastback68
Gearhead Posts: 1746
From: Sucat, Paranaque, Philippines
Registered: Jul 99
|
posted 02-24-2002 04:26 AM
In 1968 at least, Ford put a line of sealer between the tank and the chassis, centering over the screw holes. Also, the tank was held in with screws only. If you don't have a tight fit with the screws, toss them and use nuts and bolts instead. Much better.
IP: Logged |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
