11" clutch plate thickness - Mustangsandmore Forums

Brought to you in part by:

.

Mustangsandmore Forums

'64 1/2 to '73 -- The Classic Mustang

11" clutch plate thickness

profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone!

next newest topic | next oldest topic

Author	Topic: 11" clutch plate thickness
Clevo377 Gearhead Posts: 278 From: Blackburn, Victoria, Australia Registered: Nov 2000	posted 06-10-2001 06:05 AM I currently have my engine out of the car and was wondering if I should change the clutch plate. What is the minimum thickness I should let it go to before replacing it. Thanks in advance Paul IP: Logged
steve'66 Gearhead Posts: 4307 From: Sonoma,CA,USA Registered: Mar 2000	posted 06-11-2001 04:17 PM Paul, While you are there you might as well change it if it's worn at all. It's an inexpensive part and will be a big job to change later. IMO SteveW IP: Logged
Clevo377 Gearhead Posts: 278 From: Blackburn, Victoria, Australia Registered: Nov 2000	posted 06-12-2001 01:50 AM Good point. Thanks Steve Paul IP: Logged

All times are ET (US)	next newest topic \| next oldest topic
Administrative Options: Close Topic \| Archive/Move \| Delete Topic
	Hop to:

Contact Us | Mustangsandmore Front Page

Copyright 2002, Steve LaRiviere

Ultimate Bulletin Board 5.47d

Amazon Honor System

[Where are the M&M Members From?]

[About M&M][Acronym Guide][Calendar of Events][Chat Room][Classified Ads] [Links]
[Members' Photos] [Technical Articles][Ford Parts Number Deciphering
[ Mustangsandmore.com Bookstore] [Advertise on Mustangsandmore.com] [Mustangsandmore.com T-Shirts]