|
Author
|
Topic: Ignition Bezel Removal
|
Scott (69Mach)
Gearhead Posts: 727
From: Walnut Creek, CA USA
Registered: Jun 99
|
posted 03-29-2001 09:09 AM
   
I've removed the ignition key cylinder, but can't figure out how to remove the rest of the bezel. Same for the windshield wiper switch. Is there a button on the backs of these switches that I've missed that will release them???
Thanks,
Scott
IP: Logged |
pony boy
Gearhead Posts: 400
From: n.y. n.y.
Registered: Jun 2000
|
posted 03-29-2001 09:18 AM
Hi Scott, The two bezels come off differently.First for the ignition bezel,what you need to do is reach behind the dash and grab the ignition switch,while you are pushing in on the bezel you need to push in on the ignition switch,you then untwist it.It may be tricky at first,but once you do it,you'll be an expert.As for the wiper bezel.First you need to take the knob off with a small allen key,you then will see a nut that was covered by the knob.You need to unscrew it,it has a cross pattern it it,that you can usually get a needle nose plier into,I believe some of the parts places sell a special tool for this.Once you get the tip of the pliers into the groove you just unscrew it.Hope this helps take care.
IP: Logged |
Scott (69Mach)
Gearhead Posts: 727
From: Walnut Creek, CA USA
Registered: Jun 99
|
posted 03-29-2001 11:28 AM
Thanks, that was exactly what I was looking for.
IP: Logged | |
Mustangsandmore Forums
UBBFriend: Email This Page to Someone! 
